Your SpotBot Spot & Stain cleaner uses different formulas to fit your desired cleaning.
You can use either the EasyFill system formula: The EasyFill uses our 2 in 1 deep clean and antifbacterial formula. Or use the 2x Cleaning Formulas: with multiple options for cleaning, and you can add boost to customize your clean.
If you are using EasyFill system Formula follow these steps:
Remove the clean water tank from your machine by simply pulling up.
Unscrew the yellow cap from the tank.
Then add hot tap water to the water line. – make sure the tank is sitting on a flat surface when reading the fill lines.
Keep your tank on a flat surface and twist the yellow cap back on.
Firmly place the EasyFill formula bottle into the yellow cap and squeeze.
Keep squeezing until the formula reaches the EasyFill line on the tank.
Finally, simply place your tank securely back onto your SpotBot.
If you are using 2X Cleaning formula, follow these steps:
Again, lift your clean water tank from the machine.
Unscrew the yellow cap.
Add hot water to the water line – make sure the tank is sitting on a flat surface when reading the fill lines.
Add the 2x Formula of your choice until it reaches the other formula fill line.
If you are using Boost, use its measuring cap to add 1oz of Boost formula to the tank.
Twist the yellow cap back on the tank.
Finally, place your tank securely back onto your SpotBot.
Your SpotBot spot and stain cleaner is now properly filled and ready for use!