In this video we'll cover how to change the belt, remove and swap out brush rolls, and reassembly of your ProHeat 2X Revolution Pet Pro:
- You will need a Philips head screwdriver and a flat head screwdriver
- To start, unplug your machine
- Next, remove both water tanks
- Now remove the nozzle and brushroll cover from the machine
- Lay the machine on its back by pressing the recline pedal
- First, you'll need to remove the belt access door
- Press your flathead screwdriver into the slot at the back and then the front of the cover
- Lift to remove the belt access doors
- Now lay the machine on its side and with your Philips screwdriver remove the screw just underneath the wheel by twisting it counterclockwise
- Slide the wheel down to remove it
- Remove the screw to remove the brushroll end cap
- If the gear belt is broken, gently remove it
- If you are replacing your brush rolls gently remove the belt
- Remove the brush rolls from the metal post
- Be sure that the washers at the end of the brush rolls do not fall off or get lost
- Line up the new brush rolls or return your current brush rolls with the belt at the bottom end of the metal post
- To make sure they are lined up hold the end of the brush roll and twist
- The other roll will rotate with it
- The bristles should be aligned in a V pattern
- Now lay the machine on its back
- If the flat belt is broken gently remove it
- Feed a new flat belt through the opening so that it wraps around the red pulley wheel
- While keeping the belt wrapped around the pulley use your thumb to stretch the belt around the metal axle
- Now lay the machine on its side
- Check that the washers are in place
- Place the belt and end cap back on the brush rolls and secure it using the screws you removed earlier
- To secure the wheel, slide the wheel up, back into the slot, and secure it with the screw that was removed earlier by twisting it with a Philips head screwdriver
- Next, lay the machine on its back and snap the self-access door into place
- To reassemble the machine push the brush roll cover straight down
- You will hear a click from each push button when it's in place
- Line up the nozzle from the edge near the floor and rotate to snap back into place
- With your belts and brush rolls back in place you're ready to get back to cleaning with your Revolution Pet Pro
Great!
We're glad you can get back to cleaning! Should you need any additional support, please review one of the related articles below or head back to support.bissell.com.
