Enjoy the power of a vacuum and steam mop all in one in your new Symphony Pet
This video will show you basic operation of your unit
Once assembled and mop pads are attached, fill your water tank
This video will show you basic operation of your unit
Once assembled and mop pads are attached, fill your water tank
On the back of the unit, open the Easy Fill opening of the water tank and use the included water cup to fill the tank. Be sure not to overfill and use water at room temperature
Close the Easy Fill opening
The water tank holds 13oz. and will last approximately 15 minutes depending on the amount of steam used during cleaning
Pull and twist the Quick Release cord wrap clockwise to unwrap the power cord completely.
Plug in to an outlet
Wait 30 seconds for the unit to heat up
Once ready, chose the level of steam to clean your floors
Hi steam is for durable floors or sticky messes
Lo steam is for delicate floors or every day cleaning
Press the steam trigger on the underside of the handle to use steam
Push the VAC switch down to turn on the cyclonic vacuum
Begin cleaning by slowly moving the unit over the floor surface while pressing the steam trigger on the underside of the handle. Moisture on the floor is normal when using in steam mode.
When the hard floor cleaner stops emitting steam, turn the vacuum and steam off and unplug.
Open the easy fill opening of the water tank and use the water cup to add water to the tank.
Once refilled, turn the unit back on and continue cleaning.
Close the Easy Fill opening
The water tank holds 13oz. and will last approximately 15 minutes depending on the amount of steam used during cleaning
Pull and twist the Quick Release cord wrap clockwise to unwrap the power cord completely.
Plug in to an outlet
Wait 30 seconds for the unit to heat up
Once ready, chose the level of steam to clean your floors
Hi steam is for durable floors or sticky messes
Lo steam is for delicate floors or every day cleaning
Press the steam trigger on the underside of the handle to use steam
Push the VAC switch down to turn on the cyclonic vacuum
Begin cleaning by slowly moving the unit over the floor surface while pressing the steam trigger on the underside of the handle. Moisture on the floor is normal when using in steam mode.
When the hard floor cleaner stops emitting steam, turn the vacuum and steam off and unplug.
Open the easy fill opening of the water tank and use the water cup to add water to the tank.
Once refilled, turn the unit back on and continue cleaning.
Great!
We're glad you can get back to cleaning! Should you need any additional support, please review one of the related articles below or head back to support.bissell.com.
