Your PowerLifter Pet Rewind vacuum has a brush roll that may require some maintenance. Here is how you do it.
You will need a Philips screwdriver.
- Start by unplugging your machine.
- Lay the vacuum down to the ground to expose the brush roll.
- Use your Philips screwdriver to remove the 6 screws holding the brush cover.
- Then lift the brush cover off of the vacuum.
- Grab both ends of the brush and lift straight out of the vacuum. Then slip the brush off of the belt.
- Clear the brush roll of any hair and debris.
- Clean debris from the bottom of the vacuum in the motor pulley, drive belt and air passageway areas.
- To replace the belt, first replace the belt by placing it over the motor pulley. Then stretch the other end over the floor brush.
- Place both ends of the brush into the slots.
- you can now replace the bottom cover and reinsert the 6 screws using your Philips screwdriver.
We hope these steps get you back on track to using your PowerLifter Pet Rewind vacuum!
Great!
We're glad you can get back to cleaning! Should you need any additional support, please review one of the related articles below or head back to support.bissell.com.