Assembling the PowerLifter™/PowerEase vacuum is easy. We’ll show you how

• You will need a Phillips screwdriver
• First, slide the handle over the body of the vacuum
• Using your Phillips screwdriver. Insert and secure both screws on the side of the handle
• Insert hose by aligning the tabs with the slot. Then push in and rotate clockwise until it locks into place
• The other hose end will insert into the foot base door. Push the hose into place
• Neatly secure the hose by placing it in the upper hose clip
• The wand stores neatly on the back of your machine.
• Install the Pet TurboEraser in the front of the vacuum. Insert the end upward into the handle until it slides into place
• The Pet Hair Eraser tool also stores on your machine. You’ll see a spot for it on the side of your vacuum
• Your PowerLifter vacuum also includes a Febreeze filter for a fresh scent after vacuuming
• To use the Febreze filter, remove the dirt tank from the vacuum by pressing the release button and lifting away
• Lift up on the filter tab at the front of the tank to access and remove the filter already in the unit. Replace it with the Febreeze filter. Replace the dirt tank back onto the vacuum, it will click when locked into place
• Now it’s time to start using your vacuum. First, plug your vacuum into a properly grounded outlet
• Next, press the red power button with your foot then the recline pedal and pull the handle back towards you
• Make sure you’re using the right floor setting. You’ll find the dial on the foot of the vacuum. Use the lowest setting for low pile carpet or bare floors. The highest setting is best for high-pile and shag carpet
• When you’re done cleaning, turn off your vacuum with the power button.  then with the power cord unplugged, simply press the gray rewind button to wind it up

Getting started is that simple. You can now begin cleaning with your PowerLifter™/PowerEase vacuum!