Remove nozzle 

• Unplug machine and remove both tanks
• Remove the nozzle & brush roll cover - There's two different nozzle styles depending on model number
  • Model number starts with (1) or (2)
    • Pull up on nozzle
    • Use release buttons & pull up to remove brush roll cover

• If model number starts with (3)

  • Press nozzle release buttons & pull up to remove nozzle

Access belt

• Press recline pedal and lay machine on its back

• Use a flathead screwdriver and press it into slot at back and then front of belt access door > Lift to remove belt access door

• Turn machine on its side and use a Philips screwdriver to remove screw underneath wheel
• Slide wheel down to remove

• Lay machine down on its back
• Use a Philips-head screwdriver to remove screw on brush roll end cap

Inspect gear belt

• Gently remove gear belt > Check for damage
  • If gear belt is broken or damaged > Go to Parts & Accessories to replace

Remove & replace brush rolls

• There are washers at end of brush rolls > Be careful these do not fall off or get lost
• Remove brush rolls from metal posts 
• Place new brush rolls on machine > Metal post should go completely through of brush roll
  • Brush roll bristles should be aligned in a “V” pattern as pictured above
• Align brush rolls with belt at other end of foot
• Hold end of one brush roll and twist > Other brush roll should rotate with it

• Check to make sure washers are in place > Reassemble belt and end cap, > Secure with screws that were removed
• If flat belt is broken > Remove and replace belt

Replace flat belt

• Place machine on its side
• Feed new flat belt through opening so that it wraps around red pulley

• Keeping band wrapped around red pulley > Place machine on its back
• Use your thumb to stretch flat belt back to wrap around metal axle

Reassemble machine

• Reassemble wheel and belt access door

• Snap belt access door back down into place