FAQ Search Select a Category BarkBath Cleaning Formulas Cleaning Tips Commercial Products Corporate Deep Cleaners Hard Floor Cleaners Mops, Brooms and Brushes Parts and Accessories Steam Sweepers Vacuums Warranty Web Site and/or go How do I clear clogs in my AeroSwift® Vacuum? Answer: Just to be safe, unplug your machine. Remove the Easy Empty dirt tank by pushing the “Push to empty bin” button and check for debris build-up or clogs in the separator located in the cap for the dirt bin assembly (See picture). Check the upper hose by removing the hose from the back of the machine. Then, grasp the hose wand and separate it from the lower hose that enters the foot. Check for a clog within the hose by pushing a broomstick through the entire length of the hose. Note: A coat hanger is not recommended to clear a clog, it may damage the hose and not clear all the debris. Check the lower hose by removing the screw from the left side of the lower hose on back of the machine and straighten this section of hose by pulling it down or lay the machine out flat (You’ll need to push the recline pedal twice to lay the machine flat) and roll the machine on its side with the lower hose towards the top side. Look through the hose for obstructions. Push a broomstick through the lower hose to unclog. (The access plate can also be removed to provide a better view of the lower hose). Put everything back together, plug your machine in and turn the power on and check to see if dirt starts going into the dirt cup. Related Questions Why is my vacuum sounding loud? What should I check? Where can I get a replacement brush and brush belt for my BISSELL Go Vac? Why doesn't the power cord rewind fully on my Pet Hair Eraser® or Opticlean® Cyclonic Vacuum? My Powergroom® Pet Canister Vacuum power cord does not rewind fully. What should I do?