- First, check if there’s water and solution in the clean tank.
Note the tank features fill instructions for clarity.
- Is the clean tank seated properly on unit and the auto- load gasket in place correctly?
If the gasket is missing, check inside the pod for the missing gasket (with the water tank removed).
- With water in tank, hold tank over sink and press upward on the x-valve. Does tank release water?
a. If it doesn’t, you’ll need to replace the valve. You can do so by clicking here: http://www.bissell.com/cap-and-insert-for-water-tank2036675?productid=3624
b. If the valve does, go on to step 4.
- Check to see if there is spray through the hose without attachments.
a. Remove the tool on the end of the hose and see if the hose will spray. If it sprays without the tool attached, then the tool is clogged. Try cleaning the spray tip (the end of the oblong black bump right below the bristles) with a paper clip.
b. Stretch the hose out and give it a few light tugs to release any kinks in the water supply hose.
If you’re still stuck, at this point it might be best to take your SpotClean to a technician. You can find your nearest BISSELL® Authorized Service Center by clicking
http://www.bissell.com/support/product-support/service-centers or by calling 1-800-237-7691, available 24 hours a day.