FAQ Search Select a Category BarkBath Cleaning Formulas Cleaning Tips Commercial Products Corporate Deep Cleaners Hard Floor Cleaners Mops, Brooms and Brushes Parts and Accessories Steam Sweepers Vacuums Warranty Web Site and/or go Why isn't my machine spraying? Answer: - Check to ensure there is a full tank of BISSELL Hard Floor Solutions and water. - Make sure the clean water tank is inserted properly by removing the tank and re-inserting it. - Check to ensure the gasket is attached to the water tank and did not fall into the machine. Reattach this gasket if necessary. - Check the valve on the bottom of the clean water tank. The water should come out of the X-valve when pressed. If the valve is blocked, soak the cap and insert in hot tap water until the blockage clears. - Check the handle to ensure it is installed properly. Remove the handle and re-attach, making sure the handle is pushed down all the way. If you need to re-install the handle, remove the solution tank and lift the tab as you lift the handle. - Check to ensure the solution tube is inserted properly into the floor nozzle. - Clean the spray tips by bending a paper clip and inserting this into the spray tips to clean. If you continue to experience no spray, please call Consumer Services at 1-800-237-7691, Monday - Friday 8 a.m. to 10 p.m., or Saturday 9 a.m. to 8 p.m., ET. A representative will assist you. Related Questions My Steam Mop™ Select is leaking or leaving water on the floor. What should I do? My Flip-It® is leaving excess water on the floor. What do I check? Why doesn't my machine have any suction?(5) Why is my SpinWave™ leaking?