FAQ Search Select a Category BarkBath Cleaning Formulas Cleaning Tips Commercial Products Corporate Deep Cleaners Hard Floor Cleaners Mops, Brooms and Brushes Parts and Accessories Steam Sweepers Vacuums Warranty Web Site and/or go My BOLT™ has no power. What do I check? Answer: is the battery fully charged? If not.... Make sure the machine is in the "OFF" position before charging, and the charger is plugged into a working outlet. The 1311 and 1312 Series needs a full 4 hours of charging on the very first use up to 4 hours of recharging depending on the amount of use. The 1313 and 1315 series needs a full 8 hours of charging on the very first use and a full 8 hours of charging is required for the battery to regain full capacity. Be sure you are only using the charger supplied with your BOLT and that the charger is properly plugged into the charging base if the unit has one. Is the power cord plugged firmly in the outlet? If yes, the power cord is firmly plugged in... Check for a blown household fuse or breaker. Check to see if charger is properly plugged into the charging base If there is still no power after trying all these troubleshooting steps, please contact BISSELL Consumer Care at 800-237-7691. A Representative will be happy to assist you. Related Questions Why is my vacuum sounding loud? What should I check? My Momentum® or PowerTrak Cyclonic Vacuum® trips my circuit breaker. What should I do? What does the clean carpet sensor do on my Rewind? My AeroSwift™ Vacuum's belts keep breaking. What should I do?