FAQ Search Select a Category BarkBath Cleaning Formulas Cleaning Tips Commercial Products Corporate Deep Cleaners Hard Floor Cleaners Mops, Brooms and Brushes Parts and Accessories Steam Sweepers Vacuums Warranty Web Site and/or go The TurboBrush® for my Deep Clean Premier® is not spinning. What do I check? Answer: The TurboBrush® Tool is air-driven, suction may be the reason for why it is not spinning correctly (if there is not a problem with the Brush). Make sure the machine is locked in the upright position. With the tank removed, check the red lint screen at the motor duct and clean if debris is built up. Check for suction at the end of the hose without the TurboBrush tool on, if there is good suction at the end of the hose, re-attach the TurboBrush tool and try for suction again. If there still isn’t any suction, the tool may need replacing. To order the TurboBrush tool, click on this link: http://www.bissell.com/powered-turbobrush-hand-tool2036652?productid=17N4 Related Questions The 3 inch tool on my 1400 Series Little Green® sprays too wide. What should I do? How do I attach the bare floor tool for my QuickSteamer? My BISSELL SpotBot® is leaking out of the bottom of the machine. What should I check to resolve this? My 1400 Series Little Green® is leaking. What should I check?