FAQ Search Select a Category BarkBath Cleaning Formulas Cleaning Tips Commercial Products Corporate Deep Cleaners Hard Floor Cleaners Mops, Brooms and Brushes Parts and Accessories Steam Sweepers Vacuums Warranty Web Site and/or go How do I replace the belt on my PowerGlide® (1305 & 1306 models) Vacuum? Answer: Unplug the machine. To install, first remove the access plate and brush by removing the seven (7) screws and taking the access plate off. Pinch the new belt to insert in the small opening for the metal cogged pulley. Then hook it over the pulley. (See picture below). Next, insert the brush into the other end of the belt sticking out. Be careful not to knock the belt off of the metal pulley. It is a tight fit, so insert the squared end of the brush first, by pushing it halfway into the slot on the left. Then, slide the right side of the brush into the slot. Push both ends in to make sure it is fully in place. Before replacing the access plate, turn the brush a couple times making sure the belt is in place over the brush and pulley. Lastly, place the access plate into place pushing the narrow side by the hose into place first and then making sure the long end snaps into place prior to screwing the seven (7) screws into place. Related Questions Why is my vacuum sounding loud? What should I check? Where can I get a replacement brush and brush belt for my BISSELL Go Vac? My Powergroom® Pet Canister Vacuum power cord does not rewind fully. What should I do? Why doesn't the power cord rewind fully on my Pet Hair Eraser® or Opticlean® Cyclonic Vacuum?