If you are experiencing weak or no suction from the hose on your Proheat 2x Revolution Pet Pro here are a few tips that may helpL
- First, make sure the dirty water tank is empty and seated properly
- To remove, press down on the tank handle and tilt the tanks towards you and pull up and away to remove it
- Empty the tank by pulling up on the rubber tab and pouring out any dirty water
- Inspect the tank for any cracks and replace as needed
- Make sure there is no pet hair or debris on the red motor duct
- It's important that the rubber tab is sealed tightly
- Press firmly on all edges of the rubber tab to secure it
- Now with the dirty tank empty, you can replace it
- This requires a slight tilt to the tank as you return it
- Another issue that can cause low suction could be the hose isn't fully attached to the nozzle or is damaged
- Make sure the hose is snapped into place and the colored hose release clip is facing out away from the machine
- Also check to make sure the tool you're using is tightly attached to the hose
- While checking the hose and tool scan the hose to ensure there are no cracks or tears in the holes
Now you're ready to get back to cleaning with your Revolution Pet Pro
Great!
We're glad you can get back to cleaning! Should you need any additional support, please review one of the related articles below or head back to support.bissell.com.
