If you're experiencing weak or no suction from the foot on your Proheat 2x Revolution Pet Pro, here are a few tips:
- First, make sure the dirty water tank is empty and seated properly
- To remove the tank press down on the cake handle and tilt the tank towards you
- Empty the tank by pulling up on the rubber tab and pouring out any dirty water
- Inspect the tank for any cracks and replace if needed
- While removed, make sure the rubber plug on the tap is pressed in place
- Press firmly on all edges to secure it
- Make sure there is no pet hair or debris on the red motor duct
- Next, make sure the bottom cap is screwed on completely
- Now tilt the tank towards you and insert the bottom first then tilt the top of the tank towards the machine and push until it clicks into place
- Another area that can cause low suction is the front nozzle and brush roll cover
- With the machine off and unplugged use your nozzle clean-out tool to clean and remove any clogs
- You can rinse the nozzle underwater and insert the clean-out tool into the nozzle to free up any hair or debris
- Next, remove the brush roll cover by pressing the two release buttons and lifting straight up
- You can remove any hair on the brush rolls with the clean-out tool
- To replace, put the brush roll cover correctly into place by pushing it straight down until you hear a click from both push buttons
- Last, line up the nozzle with the edge near the floor, and rotate it back to snap into place
- Press down on the accessory hose door until you hear a click to ensure it is also secure
- You are now ready to get back to cleaning with your Revolution Pet Pro
Great!
We're glad you can get back to cleaning! Should you need any additional support, please review one of the related articles below or head back to support.bissell.com.
