Your CrossWave® Cordless Max vacuums and washes area rugs and hard floors. We’ll show you how to wash your hard floors in this video.
- Once your turn on your machine, select hard floor mode. Use the mode button to switch form hard floor to area rug mode as needed.
- Recline the machine to start the Brush Roll spinning. Just stand your CrossWave® up to stop the brush roll.
-
Before each clean make sure to hold the trigger for 10 seconds to prime the system.
- Hold the spray trigger to apply the cleaning solution for one full pass, moving both forward and backward, over the area you are cleaning
- When the formula is flowing, you’ll see bubbles forming at the edges of the Brush Roll Window.
- For challenging and stuck-on messes, switch to area rug mode to increase the flow of solution.
- Hold your CrossWave® over the stubborn mess while holding the spray trigger.
- Using short passes while holding down the trigger, the multi-surface brush roll will go to work.
- If you notice your CrossWave® leaving too much water on your floor, or you would like your floors to dry faster, release the spray trigger and go over your previously cleaned area with a full dry pass.
With these easy steps you are well on your way to getting a better, quicker clean, with CrossWave® Cordless.
Great!
We're glad you can get back to cleaning! Should you need any additional support, please review one of the related articles below or head back to support.bissell.com.