Check the rotating floor brush and belt on your CleanView Vacuum regularly for wear to keep them in good working order.
First, unplug the vacuum and turn it over. Using a Phillips-head screwdriver, remove the seven screws and the brush cover from the bottom of the machine.
Lift out the brush roll and clean off any strings, hair or carpet fibers. Then check the brush for damage and make sure it spins freely.
Remove the belt from around the motor pulley. Check it for any wear or warping. If either the brush roll or the belt looks worn, they will need to be replaced.
Next, clear away any debris from the air passageway.
To put the belt back on the machine, place it back over the motor pulley. Then stretch the other end over the brush roll. Push the brush roll ends into the slots. Rotate it several times by hand. If it is installed correctly, the belt will center itself on the brush.
Replace the brush cover and secure it with the seven screws.