FAQ Search Select a Category Cleaning Formulas Cleaning Tips Commercial Products Corporate Deep Cleaners Hard Floor Cleaners Mops, Brooms and Brushes Parts and Accessories Steam Sweepers Vacuums Warranty Web Site and/or go Why does my vacuum seem loud? What should I check? Answer: Before checking the possible causes for your machine being louder, please unplug the unit from the outlet. Check the Pre and Post-Motor filters for debris. Dirty filters can restrict airflow. The pre-motor foam filter is square and located in a pull out tray underneath the dirt cup. The foam filter may be hand washed in cold water with mild detergent. Reinstall the filter when it is completely dry. The Multi-Layer Post Motor Filter is rectangular and located on the side of the machine. Note: The white Multi-Layer Post Motor Filter is not washable. Detach the upper hose from the machine. Insert a broomstick into the hose to push any obstruction through to the opposite end. Remove the screw from the left side of the lower hose on the back of the unit, and straighten this section of hose by pulling it down or lay the unit out flat, and roll the unit on its side with the lower house towards the top side. Look through the hose for any obstructions. Remove the hard plastic hose wand base (once held up by the single screw) to expose the lower hose. Push a broom stick through the lower hose to unclog. (The access plate can also be removed to provide a better view of the lower hose). If you continue to experience excessive noise, please call Consumer Care at 1-800-237-7691, Monday - Friday 8 a.m. to 10 p.m., or Saturday 9 a.m. to 8 p.m., ET. A representative will assist you. Related Questions Why is my vacuum sounding loud? What should I check? Why is the brush roll on my Lift-Off® Floors & More not turning? The brush on my Powerlifter® (1307 & 1309 models) is not spinning. What do I check? My AeroSwift® Vacuum has no power. What should I do?