Loading...

Cleaning Filters: Symphony Vacuum and Steam Mop 1132

Learn how to clean filters on BISSELL Symphony Vacuum and Steam Mop in this step-by-step instructional video. Browse more videos to get the most out of your Symphony Vacuum and Steam Mop.

Video Transcript:

The key to maximum performance is having a clean filter. To clean the filter, remove the dirt tank just as if you were emptying it. Then, remove the filter cartridge from the dirt separator. Next, remove the pre-motor foam filter and brush off the debris. Then, take the post-motor filter and tap it firmly against the inside of a waste container. At this point, you can place the cleaned filter back into the dirt tank or replace it with a new filter available at Bissell.com.  Once the filter is placed into the dirt tank, return the tank to the base of the Symphony, sliding the lever to your right to lock. Cleaning the filter after each use will help your Symphony operate at peak efficiency. Some Symphony models come with an optional water filter. It is essential to check the filter and replace it when it is no longer effective. To remove the water filter, use the grips on the side of the filter and pull the filter out of the Symphony. The grains inside the water filter change from green to blue to indicate when the filter is at the end of its useful life. To replace the water filter, push the filter firmly into the Symphony until it’s flush
Located on the white label above, usually on the back of the machine.
Close

Sign up for BISSELL Emails!

Get expert advice, time-saving tips & special offers.

New Subscriber? Sign up and receive 10% off your next bissell.com purchase!

Sign Up

It looks like that is an improperly formatted email address. Please try again.
Close

Thank You For Signing Up!

Check your inbox for expert advice, time-saving
tips & special offers.

Home to a Deeper Clean®
Loading
Loading

Exclusive Offer for Email Subscribers! learn more

Signup

get free shipping on any order over $20!Learn More »