FAQ Search

and/or go

My Swiffer® BISSELL® SteamBOOST™ is leaving too much water on the floor. Why?

Answer: If the SteamBoost is leaving too much water on the floor, you may be holding the trigger down too long.  Clean by slowly passing over the surface while pressing the steam trigger to emit steam as needed.  You can hold the trigger for continuous steam but be careful not to over wet the floor.  Note, the pads are moist when using them out of the container. 

Let’s make sure the cap is secure.  If the cap isn’t on tight, it could cause the machine to leak.  Make sure the cap is in place and tightened.  See pictures below for example.

Boost Water Tank Cap

Located on the white label above, usually on the back of the machine.

Sign up for BISSELL Emails!

Get expert advice, time-saving tips & special offers.

New Subscriber? Sign up and receive 10% off your next bissell.com purchase!

Sign Up

It looks like that is an improperly formatted email address. Please try again.

Thank You For Signing Up!

Check your inbox for expert advice, time-saving
tips & special offers.

Home to a Deeper Clean®

Exclusive Offer for Email Subscribers! learn more


get free shipping on any order over $30!Learn More »